REAR SEAT SIDE AIRBAG ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL REAR SEAT AIRBAG ASSEMBLY

    CAUTION:


    • The nuts must not be reused.

    • Make sure that the bench type rear seatback pad is not deformed. If it is, replace it with a new one.


    1. Install the rear seat airbag assembly with 4 new nuts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }
    2. B001OPVE04
      Text in Illustration
      *1 Hog Ring
      *2 Clamp
      *3 Fastener

      Using hog ring pliers, install 3 new hog rings.

      Note


      • Be careful not to damage the bench type rear seatback cover.

      • Be sure to securely install the hog rings as shown in the illustration while preventing wrinkles from forming on the bench type rear seatback cover.

    3. Engage the clamp and the fastener to secure the airbag wire harness.

  2. INSTALL REAR SEATBACK ASSEMBLY

    Click here

  3. INSTALL REAR SEAT CUSHION ASSEMBLY

    Click here

  4. INSTALL REAR CENTER SEAT HEADREST ASSEMBLY

  5. INSTALL REAR SEAT HEADREST ASSEMBLY

  6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  7. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  8. INSPECT SRS WARNING LIGHT

    Click here