METER / GAUGE SYSTEM PRECAUTION

Note

When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.

System Name See Procedure
Stop and Start System

Click here

Parking Assist Monitor System (w/ Parallel Parking Assist Function)
Parking Assist Monitor System (w/o Parallel Parking Assist Function)
Power Trunk Lid System

  1. WARNING NOTIFICATION FUNCTION (w/ Telematics system with telematics transceiver)

    Note


    • Before performing inspections or repairs which may cause warning messages or DTCs to occur, such as a simulation test or road test, it is necessary to activate warning notification restraint mode so that the G-BOOK center does not recognize the warnings as real ones.

    • Warning notification restraint mode can be entered by using the GTS or operating the remote touch.

    Tech Tips

    The warning notification function sends a warning ON signal, received from the combination meter assembly via CAN communication, to the G-BOOK center using the G-BOOK device if a warning is displayed in the vehicle due to a vehicle malfunction.


    1. Warning notification restraint mode

      Tech Tips

      The warning notification function sends a warning on signal, received from the combination meter assembly via CAN communication, to the G-BOOK center using the telematics transceiver if a warning is displayed in the vehicle due to a vehicle malfunction.


      1. Warning notification restraint mode (Using the GTS)


        1. Turn the engine switch off.

        2. Connect the GTS to the DLC3.

        3. Turn the engine switch on (READY).

        4. Turn the GTS on.

        5. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

      2. Warning notification restraint mode (Using the remote touch)


        1. Enter diagnostic mode of navigation system Click here.

  2. PRECAUTION WHEN REPLACING COMBINATION METER ASSEMBLY


    1. When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.