REAR DOOR LOCK INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. INSTALL REAR DOOR INSIDE LOCKING CABLE ASSEMBLY

    Click here

  2. INSTALL REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY

    Click here

  3. INSTALL REAR DOOR LOCK ASSEMBLY

    Note


    • When reusing the removed rear door lock assembly, replace the door lock wiring harness seal with a new one.

    • Do not allow grease or dust to adhere to the door lock wiring harness seal surface.

    • Reusing the door lock wiring harness seal or using a damaged door lock wiring harness seal may cause water intrusion. This may result in a malfunction of the rear door lock assembly.


    1. Apply MP grease to the sliding parts of the rear door lock assembly.

    2. When reusing the rear door lock assembly:


      1. B001O1N

        Install a new door lock wiring harness seal to the rear door lock assembly.

    3. B001NQQE04
      Text in Illustration
      *1 Release Plate

      Insert the rear door lock assembly to release plate, and set them to the rear door panel.

    4. Make sure that the release plate is securely connected to the rear door lock assembly.

    5. Using a T30 "TORX" socket wrench, install the rear door lock assembly with the 3 screws.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

  4. INSTALL REAR DOOR GLASS ASSEMBLY

    Click here

  5. INSTALL REAR DOOR QUARTER WINDOW GLASS

    Click here

  6. INSTALL REAR DOOR LOWER WINDOW FRAME SUB-ASSEMBLY

    Click here

  7. INSTALL REAR DOOR NO. 1 VENT SEAL

    Click here

  8. INSTALL REAR DOOR GLASS RUN

    Click here

  9. INSTALL REAR DOOR FRAME GARNISH

    Click here

  10. CONNECT REAR DOOR WEATHERSTRIP

    Click here

  11. INSTALL REAR DOOR SERVICE HOLE COVER

    Click here

  12. INSTALL REAR DOOR ARMREST SET BRACKET

    Click here

  13. INSTALL REAR SIDE CURTAIN ASSEMBLY (w/ Rear Door Sunshade)

    Click here

  14. INSTALL REAR DOOR INNER GLASS WEATHERSTRIP

    Click here

  15. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  16. INSTALL COURTESY LIGHT ASSEMBLY

    Click here

  17. INSTALL REAR DOOR NO. 1 STIFFENER CUSHION

    Click here

  18. INSTALL DOOR PULL HANDLE COVER

    Click here

  19. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

    Click here

  20. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG

    Click here

  21. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  22. INITIALIZE POWER WINDOW CONTROL SYSTEM

    Click here

  23. INSPECT POWER WINDOW OPERATION

    Click here