FRONT DOOR LOCK INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. INSTALL FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY

    Click here

  2. INSTALL FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY

    Click here

  3. INSTALL FRONT DOOR LOCK ASSEMBLY

    Note


    • When reusing the removed front door lock assembly, replace the door lock wiring harness seal with a new one.

    • Do not allow grease or dust to adhere to the door lock wiring harness seal surface.

    • Reusing the door lock wiring harness seal or using a damaged door lock wiring harness seal may cause water intrusion. This may result in a malfunction of the front door lock assembly.


    1. Apply MP grease to the sliding parts of the front door lock assembly.

    2. When reusing the front door lock assembly:


      1. Install a new door lock wiring harness seal to the front door lock assembly.

    3. B001O7RE05
      Text in Illustration
      *1 Front Door Lock Open Rod

      Insert the front door lock open rod to the front door lock assembly.

    4. Make sure that the front door lock open rod is securely connected to the front door lock assembly.

    5. Using a T30 "TORX" socket wrench, install the front door lock assembly with the 3 screws.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

  4. INSTALL FRONT DOOR OUTSIDE HANDLE COVER WITH LOCK CYLINDER ASSEMBLY (for Driver Side)

    Click here

  5. INSTALL FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY

    Click here

  6. INSTALL FRONT DOOR GLASS RUN

    Click here

  7. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY

    Click here

  8. INSTALL FRONT DOOR SERVICE HOLE COVER

    Click here

  9. INSTALL FRONT DOOR ARMREST SET BRACKET

    Click here

  10. INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP

    Click here

  11. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  12. INSTALL FRONT DOOR NO. 1 STIFFENER CUSHION

    Click here

  13. INSTALL COURTESY LIGHT ASSEMBLY

    Click here

  14. INSTALL DOOR PULL HANDLE COVER

    Click here

  15. INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

    Click here

  16. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

    Click here

  17. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG

    Click here

  18. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  19. INITIALIZE POWER WINDOW CONTROL SYSTEM

    Click here

  20. INSPECT POWER WINDOW OPERATION

    Click here