INTEGRATION RELAY REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE NO. 1 RELAY BLOCK COVER


    1. B001O14

      Disengage the 2 claws and remove the No. 1 relay block cover as shown in the illustration.

  4. REMOVE ENGINE ROOM JUNCTION BLOCK ASSEMBLY


    1. Disengage the 2 claws as shown in the illustration.

      B001OEJE03
      Text in Illustration
      *1 Protective Tape - -
      *a Pulled Position - -

    2. Using pliers, pull up the engine room junction block assembly at the position indicated in the illustration and disconnect the 4 connectors from the engine room junction block assembly.

      Note

      When pulling the engine room junction block assembly, take care not to damage it.

      Tech Tips

      Tape the pliers tip before use.

    3. B001OCR

      Disconnect the 2 connectors and remove the engine room junction block assembly.

      Note


      • Do not drop or allow any impact on parts.

      • Do not touch the connector.