GENERATOR(for 130 A Type) INSTALLATION

PROCEDURE

1. INSTALL GENERATOR ASSEMBLY

   
   

   1. Install the generator assembly with the 2 bolts.

      Torque:

      52 N*m  { 530 kgf*cm, 38 ft.*lbf }

   2. Install the wire harness clamp bracket to the generator assembly with the bolt.

      Torque:

      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

   3. Connect the wire harness to terminal B with the nut.

      Torque:

      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

   4. Close the terminal cap.

   5. Connect the generator assembly connector.

2. INSTALL V-RIBBED BELT

   Click here

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.