LEXUS PARKING ASSIST-SENSOR SYSTEM, Diagnostic DTC:C1AE3

DTC Code DTC Name
C1AE3 Front Right Center Sensor

DESCRIPTION

The No. 1 ultrasonic sensor (front right center sensor) is installed on the front bumper. The ECU detects obstacles based on signals received from the No. 1 ultrasonic sensor (front right center sensor). If the No. 1 ultrasonic sensor (front right center sensor) has an open circuit or other malfunction, it will not function normally.

DTC No. DTC Detection Condition Trouble Area
C1AE3 A malfunction of the No. 1 ultrasonic sensor (front right center sensor).

  • No. 1 ultrasonic sensor (front right center sensor)

  • Harness or connector

  • Clearance warning ECU assembly

WIRING DIAGRAM

A01VZX3E03

CAUTION / NOTICE / HINT

Note

If DTCs are output after repairs, turn the engine switch on (IG) and turn the clearance sonar main switch on. Then clear the DTCs Click here.

PROCEDURE


  1. INSPECT NO. 1 ULTRASONIC SENSOR (FRONT RIGHT CENTER SENSOR)


    1. Remove the No. 1 ultrasonic sensor (front right center sensor) Click here.

    2. A01W3DNE01
      Text in Illustration
      *a

      Component without harness connected

      (No. 1 Ultrasonic Sensor (Front Right Center Sensor))

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      2 (S) - 1 (E) Always 20 to 40 kΩ

    NG

    REPLACE NO. 1 ULTRASONIC SENSOR (FRONT RIGHT CENTER SENSOR) Click here

    OK

  2. CHECK HARNESS AND CONNECTOR (NO. 1 ULTRASONIC SENSOR (FRONT RIGHT CENTER SENSOR) - CLEARANCE WARNING ECU ASSEMBLY)


    1. Disconnect the C3 No. 1 ultrasonic sensor (front right center sensor) connector.

    2. Disconnect the H61 clearance warning ECU assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      C3-2 (S) - H61-23 (S7) Always Below 1 Ω
      C3-1 (E) - H61-24 (E7) Always Below 1 Ω
      C3-2 (S) - Body ground Always 10 kΩ or higher
      C3-1 (E) - Body ground Always 10 kΩ or higher
      Result
      Result Proceed to
      NG A
      OK (for LHD) B
      OK (for RHD) C

    A

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    B

    REPLACE CLEARANCE WARNING ECU ASSEMBLY Click here

    C

    REPLACE CLEARANCE WARNING ECU ASSEMBLY Click here