TELEMATICS SYSTEM(w/ Telematics Transceiver except G-BOOK), Diagnostic DTC:B1571

DTC Code DTC Name
B1571 Green LED Error

DESCRIPTION

This DTC is stored when the telematics transceiver detects an open or short in the manual (SOS) switch indicator (green) circuit of the manual (SOS) switch.

The manual (SOS) switch indicator (green) illuminates after the engine switch is turned on (IG).

If the telematics system is not active, the manual (SOS) switch indicator (green) will turn off.

If the telematics system is active, the manual (SOS) switch indicator (green) will blink while communicating with the call center.

DTC No. Detection Item DTC Detection Condition Trouble Area
B1571 Green LED Error Current for the manual (SOS) switch indicator (green) exceeds malfunction threshold for 20 seconds when the engine switch is on (IG).

  • Telematics transceiver

  • Roof console box sub-assembly (manual (SOS) switch)

  • Wire harness or connector

WIRING DIAGRAM

A01VZ5LE19
*1 GREEN
*2 Roof Console Box Sub-assembly (Manual (SOS) Switch)
*3 Telematics Transceiver

CAUTION / NOTICE / HINT

Note

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Registration for Telematics System.

Click here

PROCEDURE


  1. CHECK DTC


    1. Turn the engine switch off.

    2. Connect the GTS to the DLC3.

    3. Turn the engine switch on (IG) and wait for 20 seconds.

    4. Turn the GTS on.

    5. Check for DTCs and check that no DTCs are output.

      Click here

      OK
      No DTCs are output.
      Result
      Proceed to
      OK
      NG

    OK

    USE SIMULATION METHOD TO CHECK Click here

    NG

  2. INSPECT ROOF CONSOLE BOX SUB-ASSEMBLY (MANUAL (SOS) SWITCH) (INPUT VOLTAGE)


    1. A01W01DC20
      *a

      Component with harness connected

      (Roof Console Box Sub-assembly (Manual (SOS) Switch))

      Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      7 (IND2) - 9 (GND3)

      2 seconds after engine switch turned on (IG)

      → Engine switch off

      8.5 to 10 V

      → Below 1 V
      Result
      Proceed to
      OK
      NG

    NG

    CHECK HARNESS AND CONNECTOR (TELEMATICS TRANSCEIVER - ROOF CONSOLE BOX SUB-ASSEMBLY (MANUAL (SOS) SWITCH)) Click here

    OK

  3. INSPECT ROOF CONSOLE BOX SUB-ASSEMBLY (MANUAL (SOS) SWITCH) (GREEN INDICATOR)


    1. A01W4I5C14
      *a

      Component without harness connected

      (Roof Console Box Sub-assembly (Manual (SOS) Switch))

      Remove the roof console box sub-assembly (manual (SOS) switch).

      Click here

    2. Connect 2 dry-cell batteries (1.5 V each) in series.

    3. Connect a positive (+) lead from batteries to terminal 7 (IND2) and a negative (-) lead to terminal 9 (GND3) of the roof console box sub-assembly (manual (SOS) switch) connector.

    4. Check if the manual (SOS) switch indicator (green) comes on.

      OK
      Manual (SOS) switch indicator (green) illuminates.
      Result
      Proceed to
      OK
      NG

    NG

    REPLACE ROOF CONSOLE BOX SUB-ASSEMBLY (MANUAL (SOS) SWITCH) Click here

    OK

  4. CHECK HARNESS AND CONNECTOR (TELEMATICS TRANSCEIVER - ROOF CONSOLE BOX SUB-ASSEMBLY (MANUAL (SOS) SWITCH))


    1. Disconnect the H101 telematics transceiver connector.

    2. Disconnect the T11 roof console box sub-assembly (manual (SOS) switch) connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      H101-12 (IND2) - T11-7 (IND2) Always Below 1 Ω
      H101-12 (IND2) or T11-7 (IND2) - Body ground Always 10 kΩ or higher
      H101-26 (SIG-) - T11-9 (GND3) Always Below 1 Ω
      H101-26 (SIG-) or T11-9 (GND3) - Body ground Always 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  5. REPLACE TELEMATICS TRANSCEIVER


    1. Replace the telematics transceiver with a new one.

      Click here

      Result
      Proceed to
      NEXT

    NEXT

    PERFORM REGISTRATION Click here