HARD DISK DRIVE REMOVAL

PROCEDURE


  1. PRECAUTION

    Note


    • After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Click here.

    • When removing the hard disk drive, eliminate static electricity by touching the vehicle body to prevent components from being damaged.

  2. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM (for Power Tilt and Power Telescopic Steering Column)

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

    Click here

  5. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL GARNISH

    Click here

  6. REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY

    Click here

  7. REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL

    Click here

  8. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET

    Click here

  9. REMOVE NO. 2 RADIO BRACKET

    Click here

  10. REMOVE HARD DISK DRIVE


    1. B001O0L

      Remove the screw and claw.

    2. B001OPR

      Remove the 3 screws and cover.

    3. B001OL2E02
      Text in Illustration
      *a Protective Tape

      Using a screwdriver with its tip wrapped with protective tape, slide the hard disk drive in the direction shown by the arrow to remove it.