NOISE FILTER REMOVAL

PROCEDURE


  1. REMOVE REAR SEATBACK ASSEMBLY

    Click here

  2. REMOVE REAR DOOR SCUFF PLATE LH

    Click here

  3. REMOVE REAR SEAT SIDE GARNISH LH

    Click here

  4. REMOVE RADIO SETTING CONDENSER (for High Mounted Stop Light)

    Note

    When the terminal cover is removed, the radio setting condenser must be replaced because the terminal cover and condenser are supplied as a set.


    1. A01W0ZU

      Remove the bolt.

    2. Disengage the clamp and disconnect the radio setting condenser with wire harness from the vehicle body.

    3. A01W4SK

      Disengage the claw and pull out the cover as shown in the illustration.

    4. A01W3HN

      Using a screwdriver, disengage the 6 claws and remove the 2 terminal covers with wire harness from the condenser.

    5. A01W0GH

      Using a screwdriver, bend back and break off the claw as shown in the illustration.

    6. Remove the terminal cover from the wire harness.

      Note


      • Make sure to hold the crimping side of the terminal when disconnecting the wire harness from the terminal cover.

      • Make sure not to bend the exposed wire when disconnecting the wire harness from the terminal cover.

      • Check for deformation of the terminal after the wire harness has been removed from the terminal cover.

  5. REMOVE ROOF SIDE INNER GARNISH ASSEMBLY LH (for Window Defogger)

    Click here

  6. REMOVE RADIO SETTING CONDENSER (for Window Defogger)

    Note

    When the terminal cover is removed, the radio setting condenser must be replaced because the terminal cover and condenser are supplied as a set.


    1. A01W4EH

      Remove the bolt.

    2. Disengage the clamp and disconnect the radio setting condenser with wire harness from the vehicle body.

    3. A01W0OC

      Using a screwdriver, disengage the 3 claws and remove the terminal cover with wire harness from the condenser.

    4. A01W4O5

      Using a screwdriver, bend back and break off the claw as shown in the illustration.

    5. Remove the terminal cover from the wire harness.

      Note


      • Make sure to hold the crimping side of the terminal when disconnecting the wire harness from the terminal cover.

      • Make sure not to bend the exposed wire when disconnecting the wire harness from the terminal cover.

      • Check for deformation of the terminal after the wire harness has been removed from the terminal cover.