FUEL PRESSURE PULSATION DAMPER INSTALLATION

PROCEDURE


  1. INSTALL FUEL PRESSURE PULSATION DAMPER ASSEMBLY


    1. B001O9SE06
      Text in Illustration
      *1 O-ring

      Apply a light coat of gasoline or spindle oil to a new O-ring.

    2. Install the O-ring to the fuel pressure pulsation damper assembly.

    3. Install the fuel pressure pulsation damper assembly with the 2 bolts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note

      Make sure that the O-ring is not cracked or jammed when installing the damper.

  2. CONNECT FUEL TUBE SUB-ASSEMBLY

    B001OM3E03
    Text in Illustration
    *1 No. 2 Fuel Pipe Clamp
    *2 Fuel Hose Clamp

    1. Connect the fuel tube.

    2. Push the fuel tube connector until it makes a "click" sound.

    3. Install a new No. 2 fuel pipe clamp.

    4. Connect the fuel tube to the fuel hose clamp.

  3. INSTALL AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. INSPECT FOR FUEL LEAK

    Click here

  6. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

    Click here