FUEL PRESSURE PULSATION DAMPER REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work Click here.

  2. DISCHARGE FUEL SYSTEM PRESSURE

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

    Click here

  5. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  6. DISCONNECT FUEL TUBE SUB-ASSEMBLY

    B001OG2E02
    Text in Illustration
    *1 No. 2 Fuel Pipe Clamp
    *2 Retainer
    *3 Fuel Hose Clamp
    *4 Fuel Tube Connector
    *a Turn

    Note

    Do not forcibly bend, kink or twist the fuel tube sub-assembly.


    1. Disconnect the fuel tube from the fuel hose clamp.

    2. Remove the No. 2 fuel pipe clamp.

    3. Wipe off any foreign matter on the fuel tube connector.

    4. Hold the fuel tube connector, and then install SST.

      SST
      09268-21011

    5. Turn SST to align the retainer inside the fuel tube connector with the chamfered part of SST.

    6. Insert SST into the fuel tube connector and hold it. Then push the fuel tube connector toward SST.

    7. Mount the retainer of the fuel tube connector onto the chamfered part of SST.

    8. B001NS5E53
      Text in Illustration
      *1 O-ring
      *2 Retainer
      *3 Fuel Tube Sub-assembly
      *4 Fuel Tube Connector
      *5 Fuel Pipe

      Slide SST and the fuel tube connector together until they make a "click" sound, and then disconnect the fuel tube.

      Note


      • Check for foreign matter in the fuel tube around the fuel tube connector. Clean it if necessary. Foreign matter can affect the ability of the O-rings to seal the fuel tube connector and fuel pipe.

      • Do not use any tools to separate the fuel tube connector and fuel pipe.

      • Do not forcibly bend, kink or twist the fuel tube.

      • Keep the fuel tube connector and fuel pipe free from foreign matter.

      • If the fuel tube connector and fuel pipe are stuck together, pinch the fuel tube connector and turn it carefully to disconnect it.

      • Cover the fuel tube connector and fuel pipe with plastic bags to prevent damage and contamination.

  7. REMOVE FUEL PRESSURE PULSATION DAMPER ASSEMBLY


    1. B001O0U

      Remove the 2 bolts and fuel pressure pulsation damper assembly.

    2. Remove the O-ring from the fuel pressure pulsation damper assembly.