FUEL INJECTOR REMOVAL

CAUTION / NOTICE / HINT

Tech Tips

Perform "Inspection After Repair" after replacing a fuel injector assembly Click here.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Click here.

  2. DISCHARGE FUEL SYSTEM PRESSURE

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

    Click here

  5. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  6. DISCONNECT FUEL TUBE SUB-ASSEMBLY

    Note

    Remove any dirt or foreign matter on the fuel tube connector and fuel pipe before performing this work.


    1. B001OF1

      Disengage the claw and remove the No. 1 fuel pipe clamp.

    2. Disconnect the fuel tube sub-assembly from the fuel pipe.


      1. B001OJBE02
        Text in Illustration
        *a Retainer
        *b O-ring
        *c Fuel Tube Connector
        *d Fuel Pipe
        *e Nylon Tube
        B001O8N Pinch
        B001OAO Pull

        Pinch the retainer of the fuel tube connector, and then pull the fuel tube connector off of the fuel pipe.

        Note

        Be sure to disconnect the fuel tube connector by hand.

      2. If the fuel tube connector and fuel pipe are stuck, push and pull the fuel tube connector to release it. Pull the fuel tube connector off of the fuel pipe carefully.

        Note


        • Be sure to disconnect the fuel tube connector by hand.

        • Do not allow any scratches or foreign matter to get on the parts when disconnecting them as the fuel tube connector has O-rings that seal the fuel pipe.

        • Do not forcibly bend, twist or turn the nylon tube.

      3. Check if there is any foreign matter on the sealing surfaces of the disconnected fuel lines. Clean them if necessary.

      4. Cover the disconnected fuel pipe and fuel tube connector with plastic bags to prevent damage and contamination.

    3. Disengage the clamp to disconnect the fuel tube sub-assembly from the fuel hose clamp.

  7. REMOVE VACUUM SWITCHING VALVE ASSEMBLY (for ACIS)

    Click here

  8. DISCONNECT WIRE HARNESS

    B001NX3

    1. Disconnect the 4 fuel injector assembly connectors, throttle body with motor assembly connector and sensor wire connector.

    2. Remove the 2 bolts and separate the 2 wire harness brackets from the intake manifold.

    3. Disengage the clamp to disconnect the wire harness.

  9. REMOVE FUEL DELIVERY PIPE


    1. B001NU6

      Remove the 2 bolts and fuel delivery pipe with the 4 fuel injector assemblies.

      Note

      Do not drop the fuel injector assemblies when removing the fuel delivery pipe.

    2. B001NVEE03
      Text in Illustration
      *1 Fuel Delivery Spacer
      *2 Injector Vibration Insulator

      Remove the 2 fuel delivery spacers from the cylinder head.

    3. Remove the 4 injector vibration insulators from the cylinder head.

  10. REMOVE FUEL INJECTOR ASSEMBLY


    1. B001NTP

      Pull the 4 fuel injector assemblies out of the fuel delivery pipe.

    2. Remove the O-ring from each fuel injector assembly.

    3. For reinstallation, attach a tag or label with the corresponding cylinder number to each fuel injector assembly.

      Note

      Protect the fuel injector assemblies by covering them with plastic bags.