ECM REMOVAL

CAUTION / NOTICE / HINT

Note

Perform the Vehicle Identification Number (VIN) registration when replacing the ECM Click here.

Tech Tips

When removing only the ECM, it is not necessary to remove the cool air intake duct seal and battery.

PROCEDURE


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE COOL AIR INTAKE DUCT SEAL

    Click here

  3. REMOVE BATTERY

    Click here

  4. REMOVE ECM


    1. B001O5T

      Disconnect the 2 ECM connectors.


      1. Push in the locks on the 2 levers, raise the levers, and disconnect the 2 ECM connectors.

        Note

        After disconnecting the connectors, make sure that dirt, water or other foreign matter does not contact the connecting part of the connectors.

    2. B001NYPE06

      Remove the nut.

    3. Remove the screw (A).

    4. Loosen the screw (B) and remove the ECM.

    5. Remove the screw (B).

    6. B001NMG

      Remove the 2 screws and No. 2 ECM bracket.

  5. REMOVE NO. 1 ECM BRACKET


    1. B001O2U

      Remove the nut.

    2. Disconnect the wire harness clamp.

    3. B001O6W

      Disconnect the wire harness clamp.

    4. B001NUK

      Remove the nut and No. 1 ECM bracket.