INITIALIZATION
Note
Perform Registration (VIN registration or frame number registration) when replacing the ECM Click here.
Before replacing the ECM, refer to Service Bulletin (for Immobiliser System).
Make sure to perform Reset Memory (AT initialization) when replacing the automatic transaxle assembly, engine assembly or ECM Click here.
When the cable is disconnected from the negative (-) battery terminal, initialize the following system(s) after the cable is reconnected.
| System Name | See Procedure |
|---|---|
| Stop and Start System | |
| Parking Assist Monitor System (w/ Parallel Parking Assist Function) | |
| Parking Assist Monitor System (w/o Parallel Parking Assist Function) | |
| Power Trunk Lid System |
When the engine stop and start ECU assembly is replaced, it is necessary to read the number of starter operations before replacement, and to store this number in the new engine stop and start ECU assembly. Moreover, initialization/learning of the air conditioning information and initialization/learning of the deceleration sensor zero point are also required Click here.
When the starter assembly is replaced, the number of starter operations stored in the engine stop and start ECU must be reset.
When the starter assembly is replaced, "ST relay" and "ST NO. 2 relay" must be also replaced.
WHEN USING GTS
CAUTION:
Observe the following items for safety reasons:
Before using the GTS, read the instruction manual.
Prevent the GTS cable from being caught on the pedals, shift lever or steering wheel when driving with the GTS connected to the vehicle.
When driving the vehicle for testing purposes using the GTS, 2 persons are required. One is for driving the vehicle, and the other operates the GTS.