HAZARD WARNING SWITCH REMOVAL

PROCEDURE

1. PRECAUTION (w/ Navigation System)

   Note

   After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (- ) battery terminal notices before proceeding with work Click here.

   Note

   w/ G-BOOK System:

   When removing the hard disk drive, eliminate static electricity by touching the vehicle body to prevent components from being damaged.

2. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM (for Power Tilt and Power Telescopic Steering Column)

   Click here

3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Navigation System)

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

4. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

   Click here

5. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL GARNISH

   Click here

6. REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY

   Click here

7. REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL

   Click here

8. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET

   Click here

9. REMOVE NO. 1 RADIO BRACKET (w/o Navigation System)

   Click here

10. REMOVE NO. 2 RADIO BRACKET (w/o Navigation System)

    Click here

11. REMOVE NO. 1 RADIO BRACKET (w/ Navigation System)

    Click here

12. REMOVE NO. 2 RADIO BRACKET (w/ Navigation System)

    Click here

13. REMOVE HARD DISK DRIVE (w/ Navigation System)

    w/ G-BOOK System: Click here

14. REMOVE RADIO RECEIVER ASSEMBLY (HAZARD SWITCH)