AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM, Diagnostic DTC:B2424, B2425

DTC Code DTC Name
B2424 Headlight Leveling Motor LH Communication Malfunction
B2425 Headlight Leveling Motor RH Communication Malfunction

DESCRIPTION

The headlight leveling ECU (headlight swivel ECU assembly) receives a signal from each headlight swivel motor (leveling function) using LIN communication.

DTC No. DTC Detection Condition Trouble Area
B2424

  • Malfunction in headlight swivel motor LH (leveling function)

  • Open or short in headlight swivel motor LH (leveling function) communication circuit

  • Headlight unit LH (headlight swivel motor LH (leveling function))

  • Harness or connector

  • Headlight leveling ECU (headlight swivel ECU assembly)
B2425

  • Malfunction in headlight swivel motor RH (leveling function)

  • Open or short in headlight swivel motor RH (leveling function) communication circuit

  • Headlight unit RH (headlight swivel motor RH (leveling function))

  • Harness or connector

  • Headlight leveling ECU (headlight swivel ECU assembly)

WIRING DIAGRAM

A01W1RTE27

CAUTION / NOTICE / HINT

Note

If the headlight leveling ECU (headlight swivel ECU assembly) has been replaced, it is necessary to synchronize the vehicle information and initialize the headlight leveling ECU (headlight swivel ECU assembly) Click here.

PROCEDURE


  1. CHECK FOR DTC


    1. Clear the DTCs Click here.

    2. Check for DTCs Click here.

      OK
      DTC B2424 and B2425 are not output.

    OK

    USE SIMULATION METHOD TO CHECK Click here

    NG

  2. CHECK HARNESS AND CONNECTOR (HEADLIGHT LEVELING ECU (HEADLIGHT SWIVEL ECU ASSEMBLY) - HEADLIGHT ASSEMBLY)


    1. Disconnect the A80 headlight leveling ECU (headlight swivel ECU assembly) connector.

    2. Disconnect the A68 headlight assembly LH connector or A72 headlight assembly RH connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      LH Side (DTC B2424)
      Tester Connection Condition Specified Condition
      A80-30 (LH+) - A68-6 (LHM+) Always Below 1 Ω
      A80-30 (LHT) - Body ground Always 10 kΩ or higher
      Standard Resistance
      RH Side (DTC B2425)
      Tester Connection Condition Specified Condition
      A80-11 (RH+) - A72-6 (RHM+) Always Below 1 Ω
      A80-11 (RHT) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. REPLACE HEADLIGHT UNIT (HEADLIGHT SWIVEL MOTOR (LEVELING FUNCTION))


    1. Replace the headlight unit (headlight swivel motor (leveling function)) with a new or known good one Click here.

    2. Check for DTCs Click here.

      OK
      DTC B2424 and B2425 are not output.

    OK

    END (HEADLIGHT UNIT (HEADLIGHT SWIVEL MOTOR (LEVELING FUNCTION)) WAS DEFECTIVE)

    NG

    REPLACE HEADLIGHT LEVELING ECU (HEADLIGHT SWIVEL ECU ASSEMBLY) Click here