BLACK OUT TAPE(for Front Door) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (- ) battery terminal notices before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG

    Click here

  4. REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

    Click here

  5. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

    Click here

  6. REMOVE DOOR PULL HANDLE COVER

    Click here

  7. REMOVE COURTESY LIGHT ASSEMBLY

    Click here

  8. REMOVE FRONT DOOR NO. 1 STIFFENER CUSHION

    Click here

  9. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  10. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP

    Click here

  11. REMOVE FRONT DOOR ARMREST SET BRACKET

    Click here

  12. REMOVE FRONT DOOR SERVICE HOLE COVER

    Click here

  13. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY

    Click here

  14. REMOVE FRONT DOOR GLASS RUN

    Click here

  15. DISCONNECT FRONT DOOR WEATHERSTRIP

    Click here

  16. REMOVE DOOR FRAME GARNISH

    Click here

  17. REMOVE FRONT DOOR REAR INNER BLACK OUT TAPE


    1. Using a heat light, heat the front door rear inner black out tape and vehicle body.

      Heating Temperature
      Item Temperature
      Vehicle Body and Front Door Rear Inner Black Out Tape 40 to 60°C (104 to 140°F)

      Note

      Do not heat the vehicle body excessively.

    2. B001NTI

      Pull back on one of the ends of the front door rear inner black out tape to remove it.

      Tech Tips

      When pulling on the black out tape, pull it parallel to the body.

  18. REMOVE FRONT INNER BLACK OUT TAPE


    1. Using a heat light, heat the front inner black out tape and vehicle body.

      Heating Temperature
      Item Temperature
      Vehicle Body and Front Inner Black Out Tape 40 to 60°C (104 to 140°F)

      Note

      Do not heat the vehicle body excessively.

    2. B001OJJ

      Pull back on one of the ends of the front inner black out tape to remove it.

      Tech Tips

      When pulling on the black out tape, pull it parallel to the body.