FRONT DOOR BELT MOULDING INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Click here.

  2. INSTALL FRONT DOOR BELT MOULDING ASSEMBLY


    1. B001NST

      Engage the guide and 6 claws to install the front door belt moulding assembly.

  3. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY

    Click here

  4. INSTALL FRONT DOOR SERVICE HOLE COVER

    Click here

  5. INSTALL FRONT DOOR ARMREST SET BRACKET

    Click here

  6. INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP

    Click here

  7. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  8. INSTALL FRONT DOOR NO. 1 STIFFENER CUSHION

    Click here

  9. INSTALL COURTESY LIGHT ASSEMBLY

    Click here

  10. INSTALL DOOR PULL HANDLE COVER

    Click here

  11. INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

    Click here

  12. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

    Click here

  13. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG

    Click here

  14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  15. INITIALIZE POWER WINDOW CONTROL SYSTEM

    Click here

  16. INSPECT POWER WINDOW OPERATION

    Click here