AMPLIFIER ANTENNA REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the amplifier antenna assembly removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Disconnect cable from negative battery terminal Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system

Click here

Memorize steering angle neutral point LKA/LDA system

Click here

Parking support brake system*
Pre-collision system
Adaptive high beam system

    Lighting system (EXT)

  • Cornering lights
Variable gear ratio steering system

Click here

Parking assist monitor system

Click here

Panoramic view monitor system

Click here

Initialize rear door sunshade system Rear door sunshade system

Click here

Initialize power trunk lid system Power trunk lid system

Click here

*: When performing learning using the GTS.
Click here Click here

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

    B006BC1

    Click here

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Click here

    CAUTION:

    B006BY6

    • Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      Click here

    • If the airbag deploys for any reason, it may cause a serious accident.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. REMOVE REAR SEAT ASSEMBLY


    1. for Fixed Seat Type:

      Click here

    2. for Power Seat:

      Click here

  5. REMOVE REAR DOOR SCUFF PLATE LH

    Click here

  6. REMOVE REAR DOOR SCUFF PLATE RH

    Click here

  7. REMOVE REAR SEAT SIDE GARNISH LH

    Click here

  8. REMOVE REAR SEAT SIDE GARNISH RH

    Click here

  9. REMOVE ROOF SIDE RAIL GARNISH ASSEMBLY LH

    Click here

  10. REMOVE ROOF SIDE RAIL GARNISH ASSEMBLY RH

    Click here

  11. REMOVE PACKAGE TRAY TRIM GARNISH LH

    Click here

  12. REMOVE PACKAGE TRAY TRIM GARNISH RH

    Click here

  13. REMOVE PACKAGE TRAY TRIM SIDE COVER LH

    Click here

  14. REMOVE PACKAGE TRAY TRIM SIDE COVER RH

    Click here

  15. REMOVE INNER ROOF SIDE GARNISH ASSEMBLY LH

    Click here

  16. REMOVE INNER ROOF SIDE GARNISH ASSEMBLY RH

    Click here

  17. REMOVE NO. 1 AMPLIFIER ANTENNA ASSEMBLY


    1. B006FELC01
      B006AHR Bolt
      B006EC9 Connector

      Disconnect the 2 connectors.

    2. Remove the bolt.

    3. Detach the guide and remove the No. 1 amplifier antenna assembly.

  18. REMOVE NO. 2 AMPLIFIER ANTENNA ASSEMBLY


    1. B006BAHC01
      B006AHR Bolt
      B006EC9 Connector

      Disconnect the 2 connectors.

    2. Remove the bolt.

    3. Detach the guide and remove the No. 2 amplifier antenna assembly.