ELECTRICAL KEY OSCILLATOR(for Roof) INSTALLATION

PROCEDURE


  1. INSTALL ROOF HEADER ELECTRICAL KEY ANTENNA


    1. Insert the guide into the roof panel hole, and install the roof header electrical key antenna with the nuts.

      Torque:
      14 N*m  { 143 kgf*cm, 10 ft.*lbf }

      Note

      Do not touch the contact terminal of the roof header electrical key antenna.

      Tech Tips

      There is a protective cover on the new roof header electrical key antenna. Remove this cover before replacing parts.

    2. Connect the connector.

      B006DE5C02
      B006AHR Nut B006EC9 Connector

  2. INSTALL ROOF HEADLINING ASSEMBLY

    Click here

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

    Click here

  5. INSPECT SRS WARNING LIGHT

    Click here

  6. INSPECT FRONT SEAT ASSEMBLY

    Click here

  7. INSPECT REAR SEAT ASSEMBLY (for Power Seat)

    Click here

  8. INSPECT SEAT HEATER SYSTEM (w/ Seat Heater System)

    Click here

  9. INSPECT CLIMATE CONTROL SEAT SYSTEM (w/ Climate Control Seat System)

    Click here

  10. INSPECT SEAT VIBRATION SYSTEM (w/ Refresh Seat)

    Click here

  11. INSPECT SEAT BELT WARNING SYSTEM

    Click here