FUEL PRESSURE DISCHARGE VALVE REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during pressure discharge valve assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function when Necessary Procedure not Performed	Link
Battery terminal is disconnected/reconnected	Memorize steering angle neutral point	LKA/LDA System	Click here
		Intelligent clearance sonar system*1
		Pre-crash safety system
		Lighting system (EXT) Cornering lights
		Adaptive high beam system
	Drive the vehicle until stop and start control is permitted (approximately 15 to 60 minutes)	Stop and start system	Click here
	Memorize steering angle neutral point	Parking Assist Monitor System (w/ Parallel Parking Assist Function)	Click here
		Parking Assist Monitor System (w/o Parallel Parking Assist Function)	Click here
		Panoramic view monitor system	Click here
	Initialize back door lock	Power door lock control system	Click here
	Reset back door close position	Power back door system	Click here

*1: When performing learning using the GTS.
Click here Click here

PROCEDURE

REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY

Click here
REMOVE FUEL SENDER GAUGE ASSEMBLY

Click here
REMOVE NO. 1 FUEL SUB-TANK

Click here
REMOVE PRESSURE DISCHARGE VALVE ASSEMBLY
1. Disconnect the 2 pressure discharge valve assembly connectors.
2. Disengage the 2 clamps to remove the fuel pump harness.
3. Disengage the 2 claws to remove the pressure discharge valve assembly from the fuel suction plate sub-assembly.