ДАТЧИК ТЕМПЕРАТУРЫ ТРАНСМИССИОННОЙ ЖИДКОСТИ УСТАНОВКА


  1. INSTALL AUTOMATIC TRANSMISSION FLUID TEMPERATURE SENSOR


    1. Coat a new O-ring with ATF and install it to the ATF temperature sensor.

    2. A01DVGXE01

      Using a 19 mm union nut wrench, install the ATF temperature sensor.

      Torque:
      29 N*m  { 300 kgf*cm, 22 ft.*lbf }

      Note

      Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench Click here.

    3. Attach the ATF temperature sensor connector clamp to the wire harness bracket.

    4. Connect the ATF temperature sensor connector.

  2. CHECK AUTOMATIC TRANSMISSION FLUID


    1. Check the automatic transmission fluid Click here.