CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the air fuel ratio sensor removal/installation are shown below.
Replacement Part or Procedure | Necessary Procedures | Effects/Inoperative when not Performed | Link |
---|---|---|---|
Replacement of air fuel ratio sensor | Inspection After Repair |
|
|
Gas leak from exhaust system is repaired |
PROCEDURE
REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR
REMOVE AIR FUEL RATIO SENSOR
CAUTION:
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
Disengage the hose clamp and separate the air fuel ratio sensor wire from the No. 1 radiator hose.
Disconnect the air fuel ratio sensor connector.
Using SST, remove the air fuel ratio sensor from the exhaust manifold.
Note
If the air fuel ratio sensor has been struck or dropped, replace it.