FRONT SPEED SENSOR(for AWD) INSTALLATION

CAUTION / NOTICE / HINT

Note

While the battery is connected, even if the engine switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal and open/close the doors while the battery is connected.

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. INSTALL FRONT SPEED SENSOR


    1. B006DIJ

      for LH Side:


      1. Install the sensor clamp with the bolt.

        Torque:
        10 N*m  { 102 kgf*cm, 7 ft.*lbf }

        Note

        Do not twist the skid control sensor wire when installing it.

      2. Install the speed sensor with the bolt.

        Torque:
        8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

        Note


        • Prevent foreign matter from attaching to the front speed sensor tip.

        • Firmly insert the front speed sensor body into the steering knuckle before tightening the bolt.

    2. B0069VQ

      for RH Side:


      1. Install the sensor clamp with the bolt.

        Torque:
        10 N*m  { 102 kgf*cm, 7 ft.*lbf }

        Note

        Do not twist the skid control sensor wire when installing it.

      2. Connect the skid control sensor wire connector.

        Torque:
        8.5 N*m  { 87 kgf*cm, 6 ft.*lbf }

        Note


        • Prevent foreign matter from attaching to the front speed sensor tip.

        • Firmly insert the front speed sensor body into the steering knuckle before tightening the bolt.

      3. Connect the pad wear indicator connector.

    3. B006COV

      Install the sensor clamp with the nut.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note

      Do not twist the skid control sensor wire when installing it.

    4. B006DZS

      Install the sensor clamp with the bolt.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note

      Do not twist the skid control sensor wire when installing it.

    5. Connect the clamp.

    6. Connect the skid control sensor wire connector.

  2. INSTALL FRONT WHEEL

    Click here

  3. CHECK FOR SPEED SENSOR SIGNAL