DRIVE BELT INSTALLATION

PROCEDURE

  1. INSTALL FAN AND GENERATOR V BELT

    1. A163771C01

      *1

      Water Pump Pulley

      *2

      Fan Pulley

      *3

      No. 1 Idler Pulley

      *4

      Vane Pump Pulley

      *5

      Generator Pulley

      *6

      V-ribbed Belt Tensioner

      *7

      Crankshaft Pulley

      *8

      Cooler Compressor Pulley

      Set the fan and generator V belt onto every part.

    2. While turning the belt tensioner counterclockwise, remove the pin.

      Note:

      Make sure that the fan and generator V belt is properly set on each pulley.

    3. Check that the belt fits properly in the ribbed grooves.

      Tip:

      Make sure to check by hand that the belt has not slipped out of the grooves on the bottom of the pulley.

  2. INSTALL UPPER RADIATOR SUPPORT SEAL

    Click hereClick hereClick here

  3. INSTALL V-BANK COVER SUB-ASSEMBLY

    Click hereClick hereClick here