PROPELLER SHAFT ASSEMBLY (for Super Long Wheelbase) REMOVAL


  1. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY


    1. B007W0TE01

      Put matchmarks on both flanges.

    2. Remove the 4 nuts, bolts and washers.

      Tech Tips

      If the flange connection is hard to separate, temporarily tighten one nut only and evenly tap the flange with a brass bar and hammer to separate the propeller with center bearing shaft assembly from the differential companion flange.

    3. B007PGH

      Remove the 2 bolts and center support bearing assembly No.1.

    4. Remove the propeller with center bearing shaft assembly.

    5. B007UO6E01

      Insert SST in the transmission to prevent oil leakage.

      Note

      Do not damage the oil seal.


      1. Use the following SST for the automatic transmission.

        SST
        09325-40010

      2. Use the following SST for the manual transmission.

        SST
        09325-20010