REAR SEATBACK HEATER(for Fixed Seat Type) INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:


  • Wear protective gloves. Sharp areas on the parts may injure your hands.

  • There is risk of injury.

B0069JE

PROCEDURE


  1. INSTALL SEAT COVER WIRE

    Click here

  2. INSTALL SEPARATE TYPE REAR SEATBACK COVER LH

    Tech Tips

    When installing a separate type rear seatback cover LH, refer to Precaution in order to prevent wrinkles from forming.

    Click here


    1. Set the separate type rear seatback cover LH.

    2. B006FY7C01
      *a Hog Ring Pliers

      Using hog ring pliers, install the separate type rear seatback cover LH to the bench type rear seatback pad with 14 new hog rings in the order indicated in the illustration.

      Note


      • Be careful not to damage the separate type rear seatback cover LH.

      • Be sure to securely install the hog rings as shown in the illustration while preventing wrinkles from forming on the separate type rear seatback cover LH.

    3. B006BOU

      Through the hole of the separate type rear seatback pad to the back side.

    4. B006G69C01
      *a Hog Ring Pliers

      Using hog ring pliers, install the separate type rear seatback cover LH to the bench type rear seatback pad with 15 new hog rings.

      Note


      • Be careful not to damage the separate type rear seatback cover LH.

      • Be sure to tighten the hog rings securely as shown in the illustration.

    5. B006CFMC01
      B006DHE Install in this Direction (1)
      B006B42 Install in this Direction (2)

      Install the strap in the installation direction (1) shown in the illustration.

    6. Install the strap in the installation direction (2) shown in the illustration.

    7. Install a new nut.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }
    8. B006CB2

      Attach the wire harness clamp.

    9. Connect the connector and install the rear seat wire LH.

    10. B006D86

      Attach the clamp and install the seat heater control sub-assembly LH.

    11. Connect the connector.

    12. B006BY7

      Attach the wire harness clamp.

    13. B006C9UC01
      *a Hog Ring Pliers

      Using hog ring pliers, install 3 new hog rings.

  3. INSTALL SEPARATE TYPE REAR SEATBACK COVER RH

    Tech Tips

    Use the same procedure described for the LH side.

  4. INSTALL REAR CENTER SEAT ARMREST ASSEMBLY

    Click here

  5. INSTALL REAR SEAT HEADREST SUPPORT

    Click here

  6. INSTALL REAR CENTER SEAT HEADREST ASSEMBLY

    Click here

  7. INSTALL REAR SEAT HEADREST ASSEMBLY

    Click here

  8. INSTALL REAR SEATBACK HOLDER

    Click here

  9. INSTALL REAR SEAT CUSHION LOCK HOOK

    Click here

  10. INSTALL REAR SEATBACK ASSEMBLY

    Click here

  11. INSTALL NO. 1 SEAT ARMREST CAP

    Click here

  12. INSTALL REAR SEAT CUSHION ASSEMBLY

    Click here

  13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  14. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

    Click here

  15. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  16. CHECK SRS WARNING LIGHT

    Click here

  17. INSPECT SEAT HEATER SYSTEM

    Click here