OIL PRESSURE SWITCH INSTALLATION

PROCEDURE

1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY

   1. Apply adhesive to 2 or 3 threads of the oil pressure switch.

      Adhesive

      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

      Note:

      Do not apply adhesive to the oil inlet port of the oil pressure switch.

   2. Install the oil pressure switch.

      15 N*m

      153 kgf*cm

      11 ft.*lbf

      Note:

      Do not start the engine within 1 hour after installation.

   3. Connect the oil pressure switch connector.

2. CHECK ENGINE OIL LEVEL

   Click here

3. INSPECT FOR OIL LEAK

   Click hereClick here

4. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

   Click hereClick hereClick hereClick hereClick hereClick here

5. INSTALL LOWER FRONT BUMPER COVER

   Click hereClick hereClick hereClick hereClick hereClick here