DRIVE BELT INSTALLATION

PROCEDURE


  1. INSTALL FAN AND GENERATOR V BELT

    A004H5QE01
    Text in Illustration
    *1 Idler
    *2 Generator
    *3 Tensioner
    *4 Water Pump
    *5 Crankshaft
    *6 A/C Compressor (w/ Air Conditioning System)
    Idler Pulley Bracket (w/o Air Conditioning System)

    1. Set the fan and generator V belt onto every part.

    2. While turning the belt tensioner clockwise, remove the 3 mm (0.118 in.) hexagon wrench.

      Note

      Make sure that the fan and generator V belt is properly installed to each pulley.

    3. Check that the fan and generator V belt fits properly in the ribbed grooves.

      Tech Tips

      Make sure to check by hand that the fan and generator V belt have not slipped out of the grooves on the bottom of the pulley.

  2. INSTALL BELT GENERATOR COVER


    1. Install the belt generator cover with the 2 blots.

      Torque:
      6.4 N*m  { 65 kgf*cm, 57 in.*lbf }

    2. Engage the 2 wire harness clamps and install the wire harness to the belt generator cover.

  3. INSTALL GENERATOR COVER


    1. Install the generator cover with the 2 blots.

      Torque:
      6.4 N*m  { 65 kgf*cm, 57 in.*lbf }

  4. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE


    1. Install the air cleaner cap with air cleaner hose with the 3 blots.

      Torque:
      6.0 N*m  { 61 kgf*cm, 53 in.*lbf }

    2. Install the air cleaner cap with air cleaner hose with the 2 hose clamps.

      Torque:
      2.0 N*m  { 20 kgf*cm, 18 in.*lbf }

    3. Connect the No. 2 ventilation hose.

    4. Connect the mass air flow meter connector.

    5. Engage the wire harness clamp and install the wire harness to the air cleaner cap.