CURTAIN SHIELD AIRBAG ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE

  1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY

    Note:

    When installing a curtain shield airbag assembly, have assistants hold it to prevent it from bending.

    1. Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Insert the 8 hooks and 3 guides to temporarily install the curtain shield airbag assembly.

      B364985C01

      *A

      for 5 Door

      *B

      for 3 Door

      *a

      Hook

      *b

      Guide

    4. Engage the 7 clips and install the curtain shield airbag assembly with 8 new bolts in the order shown in the illustration.

      9.8 N*m

      100 kgf*cm

      87 in.*lbf

      Note:

      Do not twist the curtain shield airbag assembly when installing it.

    5. B364986C01

      *a

      Airbag Connector

      *b

      Airbag Connector Lock

      Connect the airbag connector.

      Note:

      When connecting any airbag connector, take care not to damage the airbag wire harness.

    6. Push in the airbag connector lock to install the airbag connector.

  2. INSTALL ROOF HEADLINING ASSEMBLY

    for 5 Door:Click here

    for 3 Door:Click hereClick here

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick hereClick here

  4. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  5. INSPECT SRS WARNING LIGHT

    Click hereClick here