POWER BACK DOOR MAIN SWITCH INSPECTION

PROCEDURE

  1. INSPECT POWER BACK DOOR MAIN SWITCH

    1. Check the resistance.

      1. B338152C01

        *a

        Component without harness connected

        (Power Back Door Main Switch)

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection

        Switch Condition

        Specified Condition

        9 (UL) - 6 (E)

        Switch off

        10 kΩ or higher

        Switch on

        Below 1 Ω

        If the result is not as specified, replace the back door main switch.

    2. B338153C01

      *a

      Component without harness connected

      (Power Back Door Main Switch)

      Inspect the illumination operation.

      1. Apply battery voltage to the power back door main switch connector, and check that the power back door main switch LED illuminates.

        OK

        Measurement Condition

        Specified Condition

        Battery positive (+) → Terminal 8 (ILL+)

        Battery negative (-) → Terminal 7 (ILL-)

        LED illuminates

        If the result is not as specified, replace the back door main switch.