FUEL SENDER GAUGE ASSEMBLY(w/ Canister Pump Module) INSPECTION

PROCEDURE


  1. INSPECT FUEL SENDER GAGE ASSEMBLY


    1. Check that the float moves smoothly between F and E.

    2. B008HJEC01
      *a

      Component without harness connected

      (Fuel Sender Gauge Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1 - 2

      Float position is F

      (upper)

      		 13.5 to 16.5 Ω
      Float position is 1/2 200.2 to 224.8 Ω

      Float position is E

      (lower)

      		 405.5 to 414.5 Ω

      • If the value is not as specified, replace the fuel sender gauge assembly.