NOISE FILTER(for Sedan) REMOVAL

PROCEDURE

  1. REMOVE REAR SEATBACK ASSEMBLY LH

    Click here

  2. REMOVE REAR DOOR SCUFF PLATE LH

    Click hereClick hereClick here

  3. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH

    Click here

  4. REMOVE REAR SEATBACK HINGE SUB-ASSEMBLY

    Click hereClick hereClick here

  5. REMOVE REAR SEAT SIDE GARNISH LH

    Click hereClick hereClick here

  6. REMOVE ROOF SIDE INNER GARNISH ASSEMBLY LH

    Click hereClick hereClick here

  7. REMOVE RADIO SETTING CONDENSER

    Note:

    When the terminal covers are removed, the radio setting condenser must be replaced because the terminal covers and condenser are supplied as a set.

    1. E275122

      Disconnect the connector.

    2. Remove the bolt.

    3. Disengage the 3 clamps and disconnect the radio setting condenser with wire harness from the vehicle body.

    4. E226094

      Disengage the claw and pull out the cover as shown in the illustration.

    5. E232601

      Using a screwdriver, disengage the 6 claws and remove the 2 terminal covers with wire harness from the condenser.

    6. E223708

      Using a screwdriver, bend back and break off the claw as shown in the illustration.

    7. Remove the terminal cover from the wire harness.

      Note:

      • Make sure to hold the crimping side of the terminal when disconnecting the wire harness from the terminal cover.

      • Make sure not to bend the exposed wire when disconnecting the wire harness from the terminal cover.

      • Check for deformation of the terminal after the wire harness has been removed from the terminal cover.