SFI SYSTEM, Diagnostic DTC:P0531,P0532 and P0533
| DTC Code | DTC Name |
|---|---|
| P0531 | A/C Refrigerant Pressure Sensor "A" Circuit Range / Performance |
| P0532 | A/C Refrigerant Pressure Sensor "A" Circuit Low |
| P0533 | A/C Refrigerant Pressure Sensor "A" Circuit High |
DESCRIPTION
The air conditioner pressure sensor assembly is installed to the air conditioning system high pressure side pipe in the engine compartment and monitors the refrigerant pressure.
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
MIL |
Memory |
|---|---|---|---|---|---|
P0531 |
A/C Refrigerant Pressure Sensor "A" Circuit Range / Performance |
Change in air conditioner pressure sensor signal is higher than threshold. |
|
Does not Come on |
DTC stored |
P0532 |
A/C Refrigerant Pressure Sensor "A" Circuit Low |
Open or short to ground in air conditioner pressure sensor assembly circuit. |
|
Does not Come on |
DTC stored |
P0533 |
A/C Refrigerant Pressure Sensor "A" Circuit High |
Short to +B in air conditioner pressure sensor assembly circuit. |
|
Does not Come on |
DTC stored |
MONITOR DESCRIPTION
These DTCs are stored when a malfunction is detected in the air conditioner pressure sensor assembly circuit. If there is an open or short in the air conditioner pressure sensor assembly circuit or the air conditioner pressure sensor assembly value is outside of the threshold, the ECM will store a DTC.
WIRING DIAGRAM
PROCEDURE
CHECK HARNESS AND CONNECTOR (AIR CONDITIONER PRESSURE SENSOR ASSEMBLY - ECM)
Disconnect the air conditioner pressure sensor assembly connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection
Condition
Specified Condition
A14-1 (-) - A35-45 (A/C)
Always
Below 1 Ω
A14-2 (PR) - A35-33 (A/C)
Always
Below 1 Ω
A14-3 (+) - A35-21 (A/C)
Always
Below 1 Ω
A14-1 (-) or A35-45 (A/C) - Body ground and other terminals
Always
10 kΩ or higher
A14-2 (PR) or A35-33 (A/C) - Body ground and other terminals
Always
10 kΩ or higher
A14-3 (+) or A35-21 (A/C) - Body ground and other terminals
Always
10 kΩ or higher
Result
Proceed to
OK
NG
NG REPAIR OR REPLACE HARNESS OR CONNECTOR
REPLACE AIR CONDITIONER PRESSURE SENSOR ASSEMBLY
Replace the air conditioner pressure sensor assembly.
Result
Proceed to
NEXT
CHECK WHETHER DTC OUTPUT RECURS (DTC P0531, P0532 OR P0533)
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Clear the DTCs.
Powertrain > Engine > Clear DTCs
Turn the ignition switch off and wait for a few minutes.
Perform the drive test.
Turn the GTS on.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Check for DTCs.
Powertrain > Engine > Trouble Codes
Result
Result
Proceed to
DTC P0531, P0532 or P0533 is output
A
DTCs are not output
B
B END