KNOCK SENSOR INSTALLATION

PROCEDURE

  1. INSTALL KNOCK CONTROL SENSOR

    1. A212119C02

      *a

      Up

      Install the knock control sensor with the bolt.

      21 N*m

      214 kgf*cm

      15 ft.*lbf

      Note:

      • If a component has been dropped or subjected to a strong impact, replace it.

      • Make sure that the knock sensor is in the correct position.

      Tip:

      Perform "Inspection After Repairs" after replacing the knock sensor.

      Click hereClick here

    2. Connect the knock control sensor connector.

  2. INSTALL INTAKE MANIFOLD

    Click here