CLUTCH UNIT(for 1WW) REMOVAL

PROCEDURE

  1. REMOVE MANUAL TRANSAXLE ASSEMBLY

    1. Remove the manual transaxle assembly (Click here).

  2. REMOVE CLUTCH RELEASE FORK SUB-ASSEMBLY

    1. C299395

      Remove the clutch release fork sub-assembly with the clutch release bearing assembly from the manual transaxle assembly.

  3. REMOVE CLUTCH RELEASE BEARING ASSEMBLY

    1. C299396

      Remove the clutch release bearing assembly and release bearing hub clip from the clutch release fork.

  4. REMOVE CLUTCH RELEASE FORK SUPPORT BOOT

    1. C299405

      Remove the clutch release fork support boot and snap ring from the clutch release fork.

  5. REMOVE RELEASE FORK SUPPORT

    1. C299397

      Remove the release fork support from the manual transaxle assembly.

  6. REMOVE CLUTCH RELEASE FORK BOOT

    1. C299398

      Remove the clutch release fork boot from the manual transaxle assembly.

  7. REMOVE CLUTCH COVER ASSEMBLY

    1. C299399E02

      Place matchmarks on the clutch cover and flywheel.

      Table 1. Text in Illustration

      *a

      Matchmark

    2. Loosen each set bolt 180° at a time until the spring tension is released.

      Note:

      Be sure to uniformly loosen the bolts 180° at a time according to the order in the illustration.

    3. Remove the set bolts and pull off the clutch cover to remove it.

      Note:

      Do not drop the clutch disc.

  8. REMOVE CLUTCH DISC ASSEMBLY

    Note:

    Keep the lining part of the clutch disc, the pressure plate, and the surface of the flywheel away from oil and foreign matter.