BLIND SPOT MONITOR SYSTEM, Diagnostic DTC:C1ABB

DTC Code DTC Name
C1ABB Blind Spot Monitor Master Module Beam Axis Inspection Incomplete

DESCRIPTION

This DTC is stored when a beam axis inspection has not been performed for the blind spot monitor sensor LH.

Tip:

This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that beam axis inspection is performed. Completing the beam axis inspection after replacing a blind spot monitor sensor prevents this DTC from being output.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C1ABB

Blind Spot Monitor Master Module Beam Axis Inspection Incomplete

A beam axis inspection has not been performed.

Blind spot monitor sensor LH

PROCEDURE

  1. PROCEED TO TEST MODE (BLIND SPOT MONITOR BEAM AXIS INSPECTION)

    1. Using the GTS, enter Test Mode and perform the blind spot monitor beam axis inspection.

      Tip:

      Refer to Blind Spot Monitor Beam Axis Inspection.

      Click here

    Result

    Proceed to

    NEXT
    NEXT

    END