NOISE FILTER(for Wagon) INSTALLATION
PROCEDURE
INSTALL RADIO SETTING CONDENSER
-
Engage the claw to install a new terminal cover to the wire harness.
Note:Make sure to hold the crimping side of the terminal when installing the wire harness to the terminal cover.
Make sure not to bend the exposed wire when installing the wire harness to the terminal cover.
Do not use excessive force when inserting the wire harness into the terminal cover.
If the terminal cover is deformed during installation, replace the terminal and terminal cover with new ones.
-
Engage the 6 claws to install the 2 new terminal covers with wire harness to a new condenser.
Note:Do not use excessive force when inserting the terminal cover into the condenser.
If a terminal cover is deformed during installation, replace the terminal, terminal covers and condenser with new ones.
-
Insert the cover as shown in the illustration and engage the claw.
Engage the clamp to temporarily install a new radio setting condenser with wire harness.
Install the new radio setting condenser with the bolt.
8.4 N*m
86 kgf*cm
74 in.*lbf
-
INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH
INSTALL RECLINING REMOTE CONTROL BEZEL LH
INSTALL NO. 2 DECK SIDE TRIM HOOK
INSTALL REAR SEAT SIDE GARNISH LH
INSTALL REAR SEATBACK HINGE SUB-ASSEMBLY LH
INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH
INSTALL REAR DOOR SCUFF PLATE LH
INSTALL REAR SEATBACK ASSEMBLY LH
CONNECT REAR NO. 1 SEAT LOCK CABLE ASSEMBLY
INSTALL REAR SEAT HEADREST ASSEMBLY
INSTALL REAR SEAT CUSHION ASSEMBLY
INSTALL REAR DECK TRIM COVER
INSTALL ROOM PARTITION NET ASSEMBLY (w/ Partition Net)
INSTALL TONNEAU COVER ASSEMBLY
INSTALL DECK FLOOR BOX LH (w/o Woofer)
INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY (w/ Deck Board)
INSTALL REAR FLOOR MAT ASSEMBLY
INSTALL FRONT DECK FLOOR BOX (w/ Deck Board)
INSTALL DECK BOARD ASSEMBLY (w/ Deck Board)
INSTALL DECK BOARD SUB-ASSEMBLY (w/ Deck Board)