IGNITION SWITCH INSPECTION

PROCEDURE

1. INSPECT IGNITION OR STARTER SWITCH ASSEMBLY

   1. 

      *a	Component without harness connected (Ignition or Starter Switch Assembly)
      *b	LOCK
      *c	ACC
      *d	ON
      *e	START

      Check the resistance.

      1. Measure the resistance according to the value(s) in the table below.

         Standard Resistance

         Tester Connection	Switch Condition	Specified Condition
         Between all terminals	LOCK	10 kΩ or higher
         2(ACC) - 4(AM1)	ACC	Below 1 Ω
         1(IG1) - 2(ACC)- 4(AM1)	ON
         5(AM2) - 6(IG2)
         1(IG1) - 3(ST1) - 4(AM1)	START
         5(AM2) - 6(IG2) - 7(ST2)

         If the result is not as specified, replace the ignition or starter switch assembly.