FORWARD RECOGNITION CAMERA SYSTEM, Diagnostic DTC:C1AA9

DTC Code DTC Name
C1AA9 Front Camera Module Beam Axis Not Adjusted

DESCRIPTION

If forward recognition camera adjustment is not performed after installing the forward recognition camera, DTC C1AA9 is stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1AA9 Front Camera Module Beam Axis Not Adjusted 2 seconds after the power switch is turned on (IG), the forward recognition camera detects that forward recognition camera adjustment has not been completed. Forward recognition camera

CAUTION / NOTICE / HINT

Note


  • When replacing the forward recognition camera, always replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in the forward recognition camera will not match the information from the vehicle. As a result, a DTC may be stored.

  • If the forward recognition camera has been replaced with a new one, be sure to perform forward recognition camera adjustment.

    Click here

PROCEDURE


  1. CHECK FOR DTCs (FORWARD RECOGNITION CAMERA SYSTEM)


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Chassis / Front Recognition Camera / Trouble Codes.

    5. Clear the DTCs.

      Click here

    6. Perform the following procedure.

      Tech Tips

      If the following procedure is not performed, the previously output DTC cannot be detected.


      1. Turn the power switch on (IG) and wait 2 seconds or more.

    7. Check for DTCs.

      Click here

      Result
      Result Proceed to
      DTC C1AA9 is not output A
      DTC C1AA9 is output B

    A

    END

    B

  2. PERFORM FORWARD RECOGNITION CAMERA ADJUSTMENT


    1. Perform forward recognition camera adjustment.

      Click here

      Result
      Proceed to
      NEXT

    NEXT

  3. CHECK FOR DTCs (FORWARD RECOGNITION CAMERA SYSTEM)


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Chassis / Front Recognition Camera / Trouble Codes.

    5. Clear the DTCs.

      Click here

    6. Perform the following procedure.

      Tech Tips

      If the following procedure is not performed, the previously output DTC cannot be detected.


      1. Turn the power switch on (IG) and wait 2 seconds or more.

    7. Check for DTCs.

      Click here

      Result
      Result Proceed to
      DTC C1AA9 is not output A
      DTC C1AA9 is output B

    A

    END

    B

    REPLACE FORWARD RECOGNITION CAMERA Click here