CRANKSHAFT POSITION SENSOR INSTALLATION


  1. INSTALL CRANKSHAFT POSITION SENSOR


    1. B007V42

      Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.

    2. B007THJ

      Install the crankshaft position sensor with the bolt.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note

      Be careful that the O-ring is not cracked or jammed when installing the crankshaft position sensor.

    3. Connect the 3 wire harness clamps.

    4. B007VEA

      Connect the crankshaft position sensor connector to the vacuum pipe No.1.

    5. Connect the crankshaft position sensor connector.

  2. INSTALL VANE PUMP OIL RESERVOIR ASSEMBLY


    1. B007TSM

      Install the vane pump oil reservoir assembly with the 2 bolts.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

  3. INSTALL ENGINE UNDER COVER NO.1 (w/ Engine Under Cover No.1)

    Torque:
    13 N*m  { 133 kgf*cm, 10 ft.*lbf }