OIL COOLER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the oil cooler removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Replacement of CVT fluid ATF thermal degradation estimate reset The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly

Click here

PROCEDURE


  1. REMOVE NO. 1 ENGINE UNDER COVER

    Click here

  2. REMOVE REAR ENGINE UNDER COVER LH

    Click here

  3. DRAIN CONTINUOUSLY VARIABLE TRANSAXLE FLUID

    Click here

  4. DRAIN ENGINE COOLANT

    Click here

  5. REMOVE NO. 2 CYLINDER HEAD COVER

    Click here

  6. REMOVE RADIATOR COVER

    Click here

  7. REMOVE NO. 1 AIR CLEANER INLET

    Click here

  8. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE

    Click here

  9. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  10. DISCONNECT NO. 3 WATER BY-PASS HOSE


    1. A001T9RC01
      *1 No. 3 Water By-pass Hose

      Slide the clip and disconnect the No. 3 water by-pass hose from the oil cooler.

  11. DISCONNECT NO. 5 WATER BY-PASS HOSE


    1. A001V6PC01
      *1 No. 5 Water By-pass Hose

      Slide the clip and disconnect the No. 5 water by-pass hose from the oil cooler.

  12. DISCONNECT NO. 1 TRANSMISSION OIL COOLER HOSE


    1. A001V9XC01
      *1 No. 1 Transmission Oil Cooler Hose

      Slide the clip and disconnect the No. 1 transmission oil cooler hose from the oil cooler.

  13. DISCONNECT NO. 2 TRANSMISSION OIL COOLER HOSE


    1. A001XQQC01
      *1 No. 2 Transmission Oil Cooler Hose

      Slide the clip and disconnect the No. 2 transmission oil cooler hose from the oil cooler.

  14. REMOVE OIL COOLER


    1. A001SS9

      Remove the 2 bolts and oil cooler from the transmission oil cooler bracket.

  15. REMOVE TRANSMISSION OIL COOLER BRACKET


    1. A001WSV

      Remove the 3 bolts and transmission oil cooler bracket from the continuously variable transaxle assembly.