LANE RECOGNITION CAMERA SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Note:

  • If the lane departure warning camera bracket is deformed or damaged, replace it together with the windshield glass.

  • If the windshield glass is replaced on a vehicle equipped with an lane departure alert camera, make sure to use a Toyota genuine part, as the camera may not be able to be installed due to a missing bracket or the lane departure alert system may not operate properly due to a difference in the transmissivity or ceramic line shape.

  • If the lane departure warning camera is dropped, replace it with a new one.

PROCEDURE

  1. INSTALL LANE DEPARTURE WARNING CAMERA

    1. When using a new lane departure warning camera:

      1. B338909

        Remove the protective film.

        Note:

        Do not touch the camera lens after removing the protective film.

    2. Attach the 2 guides as shown in the illustration.

      B338910N01
      Note:

      Do not touch the camera lens.

    3. Attach the guide as shown in the illustration.

    4. Connect the connector and install the lane departure warning camera.

  2. INSTALL LANE DEPARTURE WARNING CAMERA COVER NO.1

    1. Attach the 4 guides and install the lane departure warning camera cover as shown in the illustration.

      B338911

  3. INSPECT LANE DEPARTURE WARNING CAMERA COVER NO.1

    1. B338912N01

      Check the clearance of area A.

      Table 1. Standard Clearance

      Area

      Measurement

      A

      0 to 2 mm (0 to 0.0787 in.)
      Tip:

      If the result is not as specified, the guides are not attached properly. Reinstall the lane departure warning camera cover.

  4. INSTALL INNER REAR VIEW MIRROR ASSEMBLY

    1. w/o EC Mirror:

      Click here

    2. w/ EC Mirror:

      Click here

  5. INSTALL RAIN SENSOR COVER

    1. Attach the 2 claws to install the rain sensor cover.

  6. ADJUST LANE DEPARTURE WARNING CAMERA

    Click here