NAVIGATION SYSTEM(for Navigation Receiver Type), Diagnostic DTC:B1579

DTC Code DTC Name
B1579 Voice Recognition Microphone Disconnected

DESCRIPTION

The navigation receiver assembly and map light assembly (telephone microphone assembly) are connected to each other using the microphone connection detection signal lines.

This DTC is stored when a microphone connection detection signal line is disconnected.

DTC Code DTC Detection Condition Trouble Area
B1579 Microphone signal is lost

  • Map light assembly

  • Telephone microphone assembly

  • Navigation receiver assembly

  • Harness or connector

WIRING DIAGRAM

A005D94E05
*a Map Light Assembly (Telephone Microphone Assembly)
*b Navigation Receiver Assembly

PROCEDURE


  1. INSPECT NAVIGATION RECEIVER ASSEMBLY


    1. A005CMFE01
      Text in Illustration
      *a

      Component with harness connected

      (Navigation Receiver Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      L38-19 (MIN-) - Body ground Always Below 1 Ω

    NG

    REPLACE NAVIGATION RECEIVER ASSEMBLY Click here

    OK

  2. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - MAP LIGHT ASSEMBLY (TELEPHONE MICROPHONE ASSEMBLY))


    1. Disconnect the L38 navigation receiver assembly connector.

    2. Disconnect the U3 map light assembly (telephone microphone assembly) connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      L38-6 (SNS2) - U3-5 (SNS2) Always Below 1 Ω
      L38-19 (MIN-) - U3-4 (MCO-) Always Below 1 Ω
      L38-6 (SNS2) - Body ground Always 10 kΩ or higher
      L38-19 (MIN-) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. INSPECT MAP LIGHT ASSEMBLY (TELEPHONE MICROPHONE ASSEMBLY)


    1. Remove the map light assembly (telephone microphone assembly) Click here.

    2. A005DZKE63
      Text in Illustration
      *a

      Component without harness connected

      (Map Light Assembly (Telephone Microphone Assembly))

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      5 (SNS2) - 4 (MCO-) Always Below 1 Ω

    OK

    REPLACE NAVIGATION RECEIVER ASSEMBLY Click here

    NG

  4. REPLACE TELEPHONE MICROPHONE ASSEMBLY


    1. Replace the telephone microphone assembly with a new or known good one Click here.

    2. Clear the DTCs Click here.

    3. Recheck for DTCs and check that no DTCs are output.

      OK
      No DTCs re output.

    OK

    END

    NG

    REPLACE MAP LIGHT ASSEMBLY Click here