ULTRASONIC SENSOR(for Hatchback Front Side, Wagon Front Side) REMOVAL

PROCEDURE

  1. REMOVE FRONT BUMPER ASSEMBLY

    Click here

  2. REMOVE NO. 2 ULTRASONIC SENSOR

    Tip:

    Use the same procedure for all No. 2 ultrasonic sensors.

    1. E262611

      Disengage the clamp.

    2. E262610

      Disconnect the connector.

    3. E262608

      Disengage the 2 claws to remove the No. 2 ultrasonic sensor.

  3. REMOVE NO. 1 ULTRASONIC SENSOR

    Tip:

    These illustrations are for the LH side. The orientation for the RH side is the opposite of the LH side.

    1. E262607

      Using a screwdriver with its tip wrapped with protective tape, slide the connector lock in the direction indicated by the arrow in the illustration.

    2. E262606

      Disconnect the connector.

    3. E262608

      Disengage the 2 claws to remove the No. 1 ultrasonic sensor.

  4. REMOVE ULTRASONIC SENSOR CLIP

    Tip:

    Use the same procedure for all ultrasonic sensor clips.

    1. E262609

      Disengage the 2 claws to remove the ultrasonic sensor clip.

  5. REMOVE ULTRASONIC SENSOR CLIP (for Simple Intelligent Parking Assist System)

    1. E262609

      Disengage the 2 claws to remove the ultrasonic sensor clip.

      Tip:

      This illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.

  6. REMOVE ULTRASONIC SENSOR BEZEL

  7. REMOVE ULTRASONIC SENSOR BEZEL (for Simple Intelligent Parking Assist System)