ROOF HEADLINING DISASSEMBLY

PROCEDURE

1. REMOVE NO. 1 ROOM LIGHT ASSEMBLY

   

   1. Disconnect the connector.

   2. Detach the 4 claws and remove the No. 1 room light.

2. REMOVE VANITY LIGHT ASSEMBLY

   

   Tip:

   Use the same procedure to remove the vanity light on the other side.

   1. Detach the 2 claws (A) and separate the bulb holder from the vanity light as shown in the illustration.

   2. Detach the claw (B) and remove the vanity light.

      Table 1. Text in Illustration

      *1	Claw (A)
      *2	Claw (B)
      *3	Bulb Holder

3. REMOVE NO. 1 ROOF SILENCER PAD (w/o Roof Sunshade System)

   

   1. Remove the 4 No. 1 roof silencer pads.

4. REMOVE NO. 2 ROOF SILENCER PAD (w/o Roof Sunshade System)

   

   1. Remove the No. 2 roof silencer pad.

5. REMOVE NO. 2 ROOF HEADLINING PAD (w/ Roof Sunshade System)

   

   1. Remove the 2 No. 2 roof headlining pads.

6. REMOVE ROOF HEADLINING PAD

   

   1. Remove the roof headlining pad.

7. REMOVE ROOF HEADLINING PAD END

   

   1. Remove the 2 roof headlining pad ends.

8. REMOVE HEADLINING SUPPORT RETAINER

   

   Tip:

   Use the same procedure to remove the headlining support retainer on the other side.

   1. Remove the headlining support retainer.

9. REMOVE NO. 1 ROOF WIRE

   1. w/o Roof Sunshade System:

      1. Turn the visor connectors approximately 90° clockwise and remove them from the roof headlining.

      2. Remove each piece of tape and the No. 1 roof wire.

      3. Remove the butyl tape remaining on the roof headlining.

         

         Table 2. Text in Illustration

         *A	w/o Pre-collision System	*B	w/ Pre-collision System
         *C	w/ Rain Sensor, for LHD	*D	w/ Rain Sensor, for RHD
         *E	w/ EC Mirror	-	-
         *1	Visor Connector	-	-
         	Tape		Butyl Tape

   2. w/ Roof Sunshade System:

      1. Turn the visor connectors approximately 90° clockwise and remove them from the roof headlining.

      2. Remove each piece of tape and the No. 1 roof wire.

      3. Remove the butyl tape remaining on the roof headlining.

         

         Table 3. Text in Illustration

         *A	w/o Pre-collision System	*B	w/ Pre-collision System
         *C	w/ Rain Sensor, for LHD	*D	w/ Rain Sensor, for RHD
         *E	w/ EC Mirror	-	-
         *1	Visor Connector	-	-
         	Tape		Butyl Tape

10. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY

    Click here