BACK-UP LIGHT SWITCH INSTALLATION

PROCEDURE

1. INSTALL BACK-UP LIGHT SWITCH ASSEMBLY

   1. Using SST, install a new gasket and back-up light switch assembly to the manual transaxle assembly.

      09817-16011

      40.2 N*m

      410 kgf*cm

      30 ft.*lbf

   2. Engage the 2 clamps to connect the back-up light switch wire harness to the manual transaxle assembly.

   3. Connect the back-up light switch assembly connector.

2. INSTALL ENGINE MOUNTING BRACKET LH

   Click hereClick hereClick here

3. INSTALL ENGINE MOUNTING INSULATOR LH

   Click hereClick hereClick here

4. INSTALL BATTERY CLAMP SUB-ASSEMBLY

   Click hereClick hereClick here

5. INSTALL BATTERY

   Click hereClick hereClick here

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click hereClick hereClick here