MILLIMETER WAVE RADAR SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during millimeter wave radar sensor assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

  • Millimeter wave radar sensor assembly

 Adjust millimeter wave radar sensor assembly

  • Dynamic radar cruise control system

  • Forward recognition camera system

  • LKA/LDA system

  • Pre-collision system

Click here

PROCEDURE


  1. REMOVE FRONT BUMPER ASSEMBLY


    1. for except Sport Package:

      Click here

    2. for Sport Package:

      Click here

  2. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY

    Note

    Do not reuse the millimeter wave radar sensor assembly if it has been dropped or subjected to a severe impact.


    1. B006BGSC01
      B006AHR Screw
      B006EC9 Bolt

      Remove the 2 bolts and 2 screws.

    2. Detach the guide and remove the millimeter wave radar sensor assembly.