COMBINATION METER REMOVAL

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE

  1. PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click hereClick hereClick hereClick hereClick here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick hereClick hereClick hereClick hereClick here

  3. REMOVE CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL

    Click hereClick here

  4. REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

    Click hereClick here

  5. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL

    Click hereClick here

  6. REMOVE COMBINATION METER ASSEMBLY

    1. E268658

      Remove the 2 screws.

    2. Detach the 2 clips and remove the combination meter assembly.

    3. B337778

      Disconnect the 2 connectors.